Tired Out,Gate Mod Planning and Got Some Metal Cut

Friday September 13, 2019 Guerneville CA.

First thing today I laid my camera down someplace outside and couldn’t find it until the end of the day.

New chicks

I checked the new chicks to make sure they were doing ok and they were. I have two so far and no more were born today as far as I can tell. I put some water and feed near the nest box so the new chicks could get some without falling down off the nest box.

Gate mod planning

Next I worked on figuring out how to change the big gate to the chicken coup, the one I drive my car through to get feed to the chickens when I buy it. I need to modify it so it works out better. I have some ideas on what to do and will get the mods done eventually. Seems I just have too much physical type stuff to do lately and  my body can’t keep up with it all, but I try just the same.

Maybe tomorrow

I was planning to ride the dirt bike up into the hills for a ride but never did get to it today. I was tired out from all the work up in the hills and had a hard time getting it going so rested up most of the afternoon.

Cut some more metal

Towards evening I got the saws all out and cut some more metal pieces on the bulkhead I’m removing. I worked almost until dark on that and was pretty beat after that. The job is getting done slowly.

That was my day I rested up as much as I could.

This entry was posted in Uncategorized. Bookmark the permalink.

One Response to Tired Out,Gate Mod Planning and Got Some Metal Cut

  1. George Yates says:

    Just pace your self and you will slowly get it done.

Comments are closed.